Ratcheting Tie Downs how to use？

Ratcheting Tie Down as the common tool for bundling logistics goods, requires skills to master the use of the method to be able to complete the bundling operation faster, while avoiding damage to the tool.

Steps to use:

• First of all, the webbing with the hook above, hooked to the goods or the body is easy to fix the position.

• Hook the hook on the ratchet buckle end of the ratchet lashing tie down straps belt to the other side.

• Thread the webbing under the ratchet shaft in the ratchet buckle and back over it (or vice versa), then pull the webbing to the desired length.

• Hold the handle again and repeatedly wiggle it back and forth to get the webbing wrapped around the ratchet shaft, at least 9/4 turns. If it's too few, the ratchet buckle can't catch the webbing and it tends to come off, and too many isn't good either. In order to avoid not winding enough turns, don't pull the webbing too tight when you put it on in the previous step to avoid not having enough length.

• After the webbing is tightened to the right degree, put the handle down flat, there is a safety, naturally locked, and then shake it will not be loose.

• If you want to unlock the cargo ratchet strap after use, hold the handle and pull the inner safety to open the safety, after opening, flip the handle 180 degrees to a horizontal state, and then go to tug a webbing, a tug can be loosened.

Ratchet Strap Selection Suggestions

In addition to using it in accordance with the prescribed operating procedures, it is also important to choose the right tensioner, otherwise it also affects the use of the effect.

For example, the length of the webbing should take into account the size of the goods, short can not be used, the pulling force should also take into account the transport situation as well as the weight of the goods, otherwise there may be a rupture of the problem, the transport process will lead to damage to the goods, so the choice of the right Ratchet Tie Down is very critical.

Selection we can consider has been the following factors:

1. webbing length and material

The webbing and lifting webbing sling are made of the same material, with a safety factor of 2 times.

The length can be chosen from 1-10m.

2. Tensile strength

The pulling force is affected by whether the webbing has a hook or not, for example, the pulling force of a single hook is only half of that of a double hook. The range of pulling force is from 750kg to 10000kg.

3. Ratchet Buckle and Accessories

The ratchet buckle can be made of different materials, e.g. plastic shanks or aluminium shanks, depending on the actual requirements.

The hooks are made of alloy steel with heat treatment, and the shapes are double row hooks, swan hooks, or just webbing without hooks, for example, heavy duty ratchet straps without hooks can be used for the bundling of container cargo.